Need help?Do you have a question about the ring Door View Cam and is the answer not in the manual?
General| Call notifications | Yes |
|---|---|
| Product color | Black, Nickel, White |
| International Protection (IP) code | IPX5 |
| Supported video modes | 1080p |
| Vertical field of view | 90 ° |
| Horizontal field of view | 155 ° |
| Frequency | 2400 MHz |
| Wi-Fi standards | 802.11b, 802.11g, Wi-Fi 4 (802.11n) |
| Connectivity technology | Wireless |
| Power source type | Battery |
| Operating temperature (T-T) | -20.5 - 48.5 °C |
Weight and Dimensions| Bell depth | 29.5 mm |
|---|---|
| Bell width | 57.4 mm |
| Bell height | 112 mm |
Steps to download and install the Ring app for setup and management of your device.
Reminder to have your Wi-Fi password ready for seamless device setup.
Guide to removing excess paint around the peephole for proper installation of the device.
Instructions for removing the outdoor part of the peephole after the indoor half is detached.
Use the Door View Key tool to smooth any sharp or jagged edges of the door hole opening.
Remove the protective orange cap from the end of the tube on the indoor side of the device.
Instructions to pinch and pull apart the indoor assembly's rear cover from the main body.
Carefully pull the grey connector cable out of the tube until there is no more slack.
Secure the indoor and outdoor parts by tightening the nut onto the tube firmly.
Slide the charged battery into the bottom of the Door View Cam until it clicks into place.
Follow in-app instructions in the Ring app to finish setting up your Door View Cam.
Press the tab into the channel to secure the cable and remove any remaining slack.
To Next Page