Rinnai Graduate MkII User Manual

GRADUATE MkII / TITAN MkII
GALAXIE MkII / GRANADA MkII
UNFLUED
with hose
CUSTOMERS OPERATING
INFORMATION
AND
INSTALLATION INSTRUCTIONS
This appliance shall be installed in accordance with:
l Manufacturer’s Instructions
l Local Authority Building Codes
l NZS 5261 Installation Code for Gas Burning Equipment
l Any other relevant Statutory Regulation
This appliance must be installed, serviced and removed by
an authorised person.
.
RiMai
GAS SPACE HEATERS

Rinnai Graduate MkII Specifications

General

Brand	Rinnai
Model	Graduate MkII
Category	Gas Heater
Language	English

Summary

Installation

Model Room Size Requirements

Specifies minimum room sizes for Titan, Graduate, Galaxie, and Granada models.

Care of Your Heater

Safety Devices

Oxygen Depletion Sensor Operation

Explains how the ODS turns the heater off due to low oxygen levels.

Flame Failure Device

Describes the device that cuts gas supply if the flame extinguishes.

Tilt Switch Operation

Explains how the tilt switch cuts gas supply if the heater is knocked over.

Important Points

Pre-Service Check List and Fault Finding

Installation Instructions

Unpacking and Initial Check

Gas Type Verification

Installation Requirements

Customers Operating Information

Ignition Procedure

Adjusting Heat Output

Wiring Diagram

Dimensions

Specification