Rinnai Granada MkII User Manual

GRADUATE MkII / TITAN MkII
GALAXIE MkII / GRANADA MkII
UNFLUED
with hose
CUSTOMERS OPERATING
INFORMATION
AND
INSTALLATION INSTRUCTIONS
This appliance shall be installed in accordance with:
l Manufacturer’s Instructions
l Local Authority Building Codes
l NZS 5261 Installation Code for Gas Burning Equipment
l Any other relevant Statutory Regulation
This appliance must be installed, serviced and removed by
an authorised person.
.
RiMai
GAS SPACE HEATERS

Rinnai Granada MkII Specifications

General

Category	Gas Heater
Model	Granada MkII
Gas Type	Natural Gas / LPG
Heating Capacity	Up to 26.1 kW
Ignition	Electronic
Safety Features	Flame Failure Device, Overheat Protection
Heat Input	26.1 kW (Natural Gas), 26.1 kW (LPG)
Heat Output	Up to 26.1 kW

Summary

Features of Your Heater

Installation

Approval

Care of Your Heater

Oxygen Depletion Sensor

Annual cleaning of the oxygen depletion sensor is recommended by Rinnai or agent.

Outer Case

Clean the outer case with a soft, damp cloth, avoiding aerosol polishes during operation.

Guarantee

Safety Devices

Oxygen Depletion Sensor

Shuts heater off if oxygen level drops, requires room ventilation before relighting.

Flame Failure Device

Automatically cuts off the gas supply if the flame goes out during operation.

Fan Switch

Provides two speed settings and an OFF position for user comfort.

Tilt Switch

Cuts gas supply if the heater is knocked over; requires re-ignition.

Important Points

Pre-Service Check List and Fault Finding

Installation Instructions

Unpacking

Undo straps, lift carton off heater carefully. Check for damage upon receipt.

Before Using The Heater

Verify correct gas type and local regulations before operating the heater.

Customers Operating Information

Wiring Diagram

Dimensions

Specification

Service Contact Point