To Next PageTo Next PageWhat to do if power interruption during bath fill with Rinnai HD32e Water Heater?
If you experience a power interruption during a bath fill and the water doesn't flow when the power is restored with your Rinnai Water Heater, turn off all hot water taps and press the ON/OFF button twice.
How to fix a noticeable reduction in water flow in my Rinnai Water Heater?
If you notice a reduction in water flow in your Rinnai Water Heater, the inlet water filter may need to be cleaned. It is recommended to schedule a service call.
What to do if there is power interruption during bath fill with my Rinnai HD32e?
If you experience a power interruption during a bath fill and the water will not flow when the power is restored, turn off all hot water taps. Then, press the On/Off button twice.
What to do if my Rinnai Water Heater starts then shuts down immediately?
If your Rinnai Water Heater starts and then shuts down immediately, ensure the power is still on. Also, check that the gas isolation valves at the unit and the gas meter are fully open. Finally, make sure to open your hot water tap fully.
What to do if Rinnai HD32e does not start?
If your Rinnai Water Heater isn't starting, make sure the power is on at the unit and check that the isolation valves are open.
What to do if Rinnai HD32e has flame failure / low gas flow?
If you're experiencing flame failure or low gas flow with your Rinnai Water Heater, start by checking that the gas is turned on at both the water heater and the gas meter or cylinder. Also, ensure there are no obstructions blocking the flue outlet.
How to fix Rinnai HD32e no ignition/no gas supply?
If your Rinnai Water Heater won't ignite due to a potential lack of gas supply, first, verify that the gas is turned on both at the water heater itself, and at the gas meter or cylinder.
What to do if Rinnai HD32e water doesn't flow after a power interruption during bath fill?
If your Rinnai Water Heater experiences a power interruption while filling a bath and water doesn't flow when power is restored, turn off all hot water taps, then press the On/Off button twice.
What to do if Rinnai HD32e Water Heater starts then the water goes cold?
If your Rinnai Water Heater starts but the water then goes cold, check that the power is still on. Open your hot water tap further, or try another tap. Note that your unit requires a minimum flow of 3L/min to operate.
What to do if Flame Failure or Low gas flow in Rinnai Water Heater?
If you experience flame failure or low gas flow in your Rinnai Water Heater, first check that the gas is turned on at both the water heater and the gas meter. Then, check that nothing is obstructing the flue outlet. Finally, ensure you turn on the gas supply to the water heater.
General| Model | HD32e |
|---|---|
| Category | Tankless Water Heater |
| Fuel Type | Natural Gas |
| GPM at 35°F Rise | 3.2 GPM |
| Temperature Range | 98°F - 140°F |
| Venting Size | 3" |
| Electrical Requirements | 120 VAC |
| Ignition Type | Electronic |
