To Next PageTo Next PageWhat to do if Rinnai HD32e starts then shuts down immediately?
If your Rinnai Water Heater starts and then immediately shuts down, verify that the power is still on. Also, check that the gas valve at the unit and the gas meter are fully open. Ensure that your hot water tap is fully open as well.
What to do if there is a power interruption during bath fill with my Rinnai HD32e Water Heater?
If there's a power interruption during a bath fill and water won't flow on power reinstatement with your Rinnai Water Heater, turn off all hot water taps and press the On/Off button twice.
Why does my Rinnai HD32e Water Heater start and then the water goes cold?
If your Rinnai Water Heater starts and then the water goes cold, verify that the power is still on. Also, try opening your hot water tap further.
What to do if my Rinnai HD32e Water Heater starts then the water goes cold?
If your Rinnai Water Heater starts but the water goes cold, verify that the power is still on. Additionally, try opening your hot water tap further.
What to do if my Rinnai Water Heater has no ignition or gas supply?
If your Rinnai Water Heater has no ignition or gas supply, check that the gas is turned on at both the water heater and the gas meter or cylinder.
General| Model | HD32e |
|---|---|
| Category | Tankless Water Heater |
| Fuel Type | Natural Gas |
| GPM at 35°F Rise | 3.2 GPM |
| Temperature Range | 98°F - 140°F |
| Venting Size | 3" |
| Electrical Requirements | 120 VAC |
| Ignition Type | Electronic |
