What to do if my Rinnai Infinity XR32 Water Heater starts then shuts down immediately?
If your Rinnai Water Heater starts and then shuts down immediately, verify that the power is still on. Also, check that the gas isolation valves at both the unit and the gas meter are fully open. Ensure that your hot water tap is fully open as well.
What to do if my Rinnai Infinity XR32 Water Heater starts then the water goes cold?
If your Rinnai Water Heater starts, but the water then goes cold, first ensure that the power is still on. Additionally, make sure that your hot water tap is fully open.
What to do if my Rinnai Infinity XR32 does not attempt to start at all?
If your Rinnai Water Heater does not attempt to start at all, verify that the power is on at the unit. Also, check that the isolation valves at the unit are open.
Why is there no ignition or gas supply to my Rinnai Water Heater?
If there is no ignition or gas supply to your Rinnai Water Heater, check that the gas is turned on at both the water heater and the gas meter or cylinder.
What causes flame failure or low gas flow in a Rinnai Water Heater?
Flame failure or low gas flow in your Rinnai Water Heater can be due to the gas supply being off at the water heater, gas meter, or cylinder. Ensure the gas is turned on at all these points. Also, check for any obstructions to the flue outlet.
How to fix a noticeable reduction in water flow in my Rinnai Infinity XR32 Water Heater?
A noticeable reduction in water flow in your Rinnai Water Heater could mean that the inlet water filter needs to be cleaned. A service call might be required.
General| Model Number | XR32 |
|---|---|
| Category | Water Heater |
| Type | Continuous Flow |
| Maximum Gas Input | 32 MJ/h |
| Minimum Gas Input | 10 MJ/h |
| Ignition | Electronic |
| Gas Type | Natural Gas |
| Temperature Range | 35°C - 60°C |
| Temperature Control | Digital |
To Next Page
