TURNING ON
Press the ON/OFF button to operate the heater. The ON
indicator will glow green. After approximately 20 seconds
the spark generator will be heard before the burner
ignites and the ON indicator glows red, indicating that the
burner is lit. Warm air can be felt coming from the
louvers 15 seconds later.
If the heater does not ignite on initial try, air may be remaining in the gas supply line.
The spark generator will only continue for 30 seconds. After this, it will be necessary to press the
ON/OFF button OFF, then ON again.
TURNING OFF
Simply press the ON/OFF button to switch off the heater. The
ON indicator will go out. The convection fan will continue to
operate for several minutes after the burner has gone out in
order to cool the appliance. Do not unplug the appliance
while the convection fan is running.
DO NOT turn heater off by unplugging.
The convection fan will continue to run until the appliance cools.
ROOM TEMPERATURE ADJUSTMENT
The room temperature and pre-set temperatures can only be displayed and adjusted when the
heater is running.
Press the " " button to increase the temperature setting
or " " button to decrease the temperature setting.
The temperatures can be preset to:
a) [L] low (about 50
°F)
b) [60
°F] to [80°F] in 2°F increments
c) [H] (continuously high)
If the heater does not ignite then the pre-set temperature may not be set to a setting which is
higher than the actual room temperature.
AUTO-OFF FUNCTION
When you select AUTO-OFF, the indicator light will glow.
You have selected a Full Thermostat Control Function.
The heater will cycle High, Low and OFF to maintain the
selected room temperatures.
When the AUTO-OFF indicator is not glowing, you have
selected a manual on/off mode of operation. The unit will
continue to produce at least 4000 BTU/h of heat until you
turn the unit off manually.
- 12 -
OPERATING THE HEATER
To Next Page
Loading...
Need help?
General