Agility 4 Quick Installation Guide
4
2. Using the mounting bracket as a template, mark and then drill the mounting holes (plus
another hole for the tamper switch), and install the anchors to the wall. Then secure the
mounting bracket to the wall with the provided screws.
3. Connect the AC power cable only to the power supply terminals located on the backside of the
mounting bracket. Then route the AC power cable via the dedicated hook [2] and opening [3]
on the bracket. Ensure compliance with proper grounding requirements, according to
applicable code and regulation (see Full Installation Manual), but DO NOT yet connect the
main panel to the electrical power supply (wall outlet or circuit breaker).
4. Remove screw and open the battery compartment cover. Observing the correct polarity,
connect the respective leads to the backup battery.
NOTE: The backup battery takes 24-hours to charge.
5. Adjust the tamper switch per customer requirements – for triggering a tamper alarm upon
main panel (box) tampering, or both wall and box tampering.
6. On the respective terminal blocks, as required, connect all wiring such as phone and network
(IP) cables.
7. Insert a SIM card into the SIM card holder as required.
8. Re-connect the flat ribbon cable, and re-connect the main panel to the bracket, fastening them
with the 2 locking screws.
9. Now power-up the main panel by connecting the main panel to the electrical power supply
(wall outlet or circuit breaker); "Security system is on" will be announced.
3. LCD Keypad Allocation and Language Selection
Newly installed systems require that the 2-way wireless LCD keypad be the first device to be
allocated (enrolled) to the system, from which a default language is then defined.
To allocate the LCD keypad and define the system language:
1. After powering-up, press the button on the main panel for 5 seconds; the unit beeps once as it
enters “Learn” mode, and the LEDs light up, one-after-the-other.
2. Before performing other device allocations, first, allocate the LCD keypad to the system by
pressing both / simultaneously for at least 2 seconds.
3. In the displayed language menu, select the system language (and customer default) settings
and then press / .
NOTE: If the keypad goes into “sleep mode” before finishing language selection, restore the
system language selection on the keypad by simultaneously pressing * and 9.
To Next Page
