Risco ProSYS User Manual

Quick Programming Setup
ProSYS Ver 7.xx
For detailed information please refer to the full ProSYS Installer Manual
provided on our website: www.riscogroup.com

Risco ProSYS Specifications

General

Wireless Zones	Up to 120
Communication	PSTN, GSM, IP
Programming	Keypad, PC
Battery Backup	12V/7Ah
Operating Temperature	-10°C to +55°C
System Type	Hybrid

Summary

Installing Hardware (Devices)

BUS Connection

Explains the Expansion BUS terminals and color-coded wires for system connectivity.

Setting BUS Accessory ID Numbers

Setting Zone Inputs Connection

Wiring Auxiliary Devices (Sensors)

Wiring Internal Bell

Bell Tamper Wiring

Wiring UO1 to Activate External Siren

Wiring the GSM Module

Wiring BUS Detectors

Connecting BUS Detectors to the ProSYS panel

Setting detector IDs and wiring directly to the panel.

Connecting BUS Detectors using a BUS Zone Expander

Wiring detectors via a BUS Zone Expander.

Programming the System

Power Up and Enter Installer Mode

Steps to power up and access installer programming mode.

Identifying Connected Devices

Automatic Settings

Auto-detection of connected devices on the BUS.

Bus Test

Verifies connectivity of BUS devices.

Programming: SYSTEM

SYSTEM - Timers

Configuring system timers like entry/exit delays.

SYSTEM - Controls

Setting system control options.

SYSTEM - Set Clock

Programming: Wireless ZONES

ZONES - Wireless Calibration

Calibrating the wireless receiver threshold.

ZONES - Wireless Zone Allocation

Enrolling wireless devices onto zones.

ZONES - Wireless Communication Test

Programming: ZONES Wired & Wireless (Attributes)

PARTITIONS

Assigning zones to specific partitions.

ZONE TYPE

ZONE SOUND

ZONE TERMINATION

ZONE RESPONSE

Programming BUS Detectors

Step 1: Adding BUS Detector to the Main Unit

Step 3: Programming the BUS Detectors Full Parameters

Programming BUS Detectors on a BUS Zone Expander

Step 1: Adding the BUS Zone Expander to ProSYS

Step 2: Assign BUS Detectors to a Zone ID and set basic parameters

Step 3: Setting the BUS Detectors Parameters

Programming: Dialer (For PSTN Dialing)

DIALER - Link-Up

DIALER - Communication Format

DIALER - Control

DIALER - Auto Codes

DIALER - Follow Me

Programming: PROG OUTPUTS

PROG OUTPUTS - Define

Codes (Changing the Installer code)

Exiting Programming Mode

[2] Zones

Zone Configuration and Settings

[3] Utility Output

System and Partition Outputs

[4] Code Maintenance

[5] Dialer

Dialer Link-Up and Communication

[7] Accessories

Accessory Management

ACM and Access Control

Email

Email Notification Settings

[83] GSM

GSM Parameters and Control