2 ProSYS Quick Programming Setup
Table of Contents
Introduction.......................................................................................................................... 3
I. Suitable Locations ............................................................................................................ 3
II. Installing Hardware (Devices) ......................................................................................... 3
1. BUS Connection ......................................................................................................... 3
2. Setting Zone Inputs Connection ................................................................................ 5
3. Wiring Auxiliary Devices (Sensors) ........................................................................... 6
4. Wiring Internal Bell ..................................................................................................... 6
5. Bell Tamper Wiring (Terminal Bell TMP) ................................................................... 6
6. Wiring UO1 to Activate Any External Stand-alone Siren .......................................... 7
7. Wiring Important BUS Accessories ........................................................................... 7
III. Programming the System ............................................................................................. 10
Power Up and Enter Installer Mode ............................................................................. 10
Identifying the Connected Devices (including BUS Detectors) ................................. 11
Programming: SYSTEM ............................................................................................... 11
Programming: Wireless ZONES .................................................................................. 12
Programming: ZONES Wired & Wireless (Attributes) ................................................ 13
Programming BUS Detectors ...................................................................................... 14
Programming: Dialer (For PSTN Dialing) .................................................................... 17
Programming: PROG OUTPUTS .................................................................................. 18
Codes (Changing the Installer code) ........................................................................... 19
System Backup ............................................................................................................. 19
Exiting Programming Mode ......................................................................................... 19
Installer Programming Menu Maps ................................................................................... 20
Technical Specifications ................................................................................................... 26
CE Declaration of Conformity ...................................................................................... 27
Compliance Statement ................................................................................................. 27
RISCO Group Limited Warranty .................................................................................. 28
Contacting RISCO Group ............................................................................................. 28
To Next Page
Loading...
