Risco ProSYS User Manual

12 ProSYS Quick Programming Setup
SYSTEM - Set Clock
QUICK KEYS = [1][3]
1. Using the / keys, select [SET CLOCK] and press .
2. Using the
/ keys, select [SYSTEM TIME] and press .
3. Using the numeric keys, enter the current time and press
.
4. Using the
/ keys, select [SYSTEM DATE] and press .
5. Using the numeric keys, enter the day (01 to 31).
6. Using the
key, select the current month.
7. Press the
button once to advance the cursor one position right.
8. Using the numeric keys, enter the current year and press
.
Programming: Wireless ZONES
ZONES - Wireless Calibration (Wireless Receiver background noise threshold setting)
QUICK KEYS = [2][9][5]
1. Using the / keys, select [MAINTENANCE] and press .
2. Using the
/ select [WL CALIBRATE] and press .
3. Using the
/ select the Wireless Receiver and press .
4. Using the
key, choose [Y] (Yes) to ‘Re-Calibrate’ the Wireless Receiver and press
.
5. After a short while, the measured background noise will be shown.
6. Add 10 to the displayed ‘NEW THOLD’ (New Threshold) by using the numeric keys and
press
.
Explanation:
The Calibration measurement above shows the amount of background ‘noise’ that the receiver
can ‘hear’ on the same frequency as the RISCO wireless devices. This ‘noise’ could be
neighboring devices of another system or other devices operating on the same frequency
nearby. These are ‘unwanted’ signals that the ProSYS wireless receiver must be told ‘not to
listen to’.
The threshold (set above) is the absolute minimum signal strength needed to be heard from a
wireless device in order for the receiver to effectively ‘hear it’. This ‘threshold’ is set at ten above
the background ‘noise’ (recommended) making the receiver ignore the unwanted signals.
With this threshold set, the ProSYS receiver will only hear its own devices which are nearer and
have a signal strength greater that the threshold level set.
ZONES - Wireless Zone Allocation (Enrolling the wireless devices)
QUICK KEYS = [2][9][6]
1. Using the / keys, select [MAINTENANCE] and press .
2. Using the
/ keys, select [WL ZONE ALLOC] and press .
3. Using the numeric keys, enter the desired zone number and press
.
4. Using the
/ keys, select [(RE)WRITE] and press .
5. Depending on the wireless device enrolled, please do one of the following:

Risco ProSYS Specifications

General

Wireless Zones	Up to 120
Communication	PSTN, GSM, IP
Programming	Keypad, PC
Battery Backup	12V/7Ah
Operating Temperature	-10°C to +55°C
System Type	Hybrid