Installation and Programming Manual 3-75
7) Accessories
This section of Installer Programming makes it possible for the Pro-24 to recognize when both Keypads and/or
Expansion Modules are added to, or deleted from, the installation. Also accessible from within this section are
some system tests which permit you to verify those keypads and modules which have been installed–by checking
their presence and the quality of their connections to the 4-wire BUS. Walk Testing, another system check (which is
not a part of these tests, see page 3-84), can be easily performed from within the Pro-24’s User Functions mode.
With the display showing:
ACCESSORIES: ADD/DELETE MODULE
Quick Key Item Default Explanation
7
ADD/DELETE
MODULE
---
• used to add or delete Keypads and Expansion
Modules to and from the system
• press [ENTER] to begin
7 1 1 Keypad NONE at this display:
using either the UP- or DOWN-arrow keys, position
the cursor over the Keypad I.D. number for which you
wish to assign (or delete) a keypad
the first keypad must be assigned to the first I.D.
number, which is “01”
be sure that the keypad’s physical I.D. number has
been “DIP-switch” programmed accordingly, per the
instructions on page 2-5
with the cursor positioned over the “TYPE” field,
press the [STAY] key to toggle between and choose
among the four selections given:
NONE
LCD (any LCD Keypad)
KP08 (the 8 LED Keypad)
KP16 (the 16 LED Keypad)
once the proper selection is made, press the
[ENTER] key to store your choice
proceed to ASSIGNING A PARTITION
on page 3-76
PLEASE NOTE
:
the following display will appear if a keypad is
found and “NONE” has been selected; if so:
press [ENTER] to return to the prior display
OR
press the [STAY] key to select “Y”, and press
[ENTER] to confirm the delete
INSTALLER PROG:
7)ACCESSORIES ¤
INSTALLER PROG:
7)ACCESSORIES
↓
press [ENTER] to begin. The first sub-category, ADD/DELETE MODULES will
appear on the display. You may enter it by pressing [ENTER] OR by pressing
the [1] key.
..DELETE..
RE YOU SURE? N
KEYPADS:
ID=01 TYPE=NONE
To Next Page
Loading...
