Installation and Programming Manual
3-84
ACCESSORIES: BUS SCANNING
Quick Key Item Explanation
BUS SCANNING scans the BUS and reports all modules found
from this display, press [ENTER]
BUS Scanning begins
7 4
scroll down the list of displayed
accessory devices to ascertain
that all Keypads and Expansion
Modules in the installation have
been detected by the scan
the system will display the
programmed device and, its
address
WALK TESTING
As a form of system maintenance, comprehensive Walk-Testing should be part of the procedures performed in
any installation–at the time of its completion, and periodically–by both the dealer and the customer.
When conducted within the User Functions mode, Walk-Testing permits any of the Pro-24’s keypads (whose
“Local Buzzers” have been enabled under User Functions–see the Pro-24 User’s Manual) to briefly annunciate
any and all zones which have been violated during the test. Once done, you can use the keypad’s UP- or
DOWN-arrow keys to scroll through a list of the zones, which have been logged during the test.
INSTALLER PROG:
7)ACCESSORIES
↓
CCESSORIES:
4)BUS SCANNING ¤
BUS SCANNING:
TYP=LCD ID=01 ↓
BUS SCANNING
TYP=KP08 ID=02 ¤
BUS SCANNING:
TYP=UO04 ID=01 ¤
BUS SCANNING:
TYP=XO08 ID=02 ↑
To Next Page
Loading...
