Installation and Programming Manual
3-24
IMPORTANT:
in One-By-One, the listing of each zone’s parameters are
sequential; thus, once Zone 1’s parameters have been
programmed, they will be followed by Zone 2’s, then Zone 3’s, and
so forth
if you choose to program one or more of the system’s zones using
the One-By-One method, changes you make to any (or all) of the
Zone Parameters will NOT be recorded unless you go through the
entire One-by-One list–which ends with the Zone Label parameter
of the last zone you wish to program
after making any changes to the above-mentioned Zone Label
parameter, press [ENTER]
doing so will produce a one-second tone
only then can you be assured that change(s) you made to the zone
being programmed will be recorded when you exit the One-by-One
Programming Mode
as an alternative to One-By-One programming (in which all of a
zone’s parameters may be programmed at the same time), you
can select a single parameter and program (or review) it for each of
the system’s zones
to do so, choose a specific zone parameter among the following six
zone categories:
2) Partitions
3) Zone Type
4) Zone Sound
5) Zone Termination
6) Loop Response
7) Zone Labels
8) Miscellaneous
page 3-25
page 3-25
page 3-28
page 3-29
page 3-29
page 3-31
page 3-85
To Next Page
Loading...
