Risco Pro-24 - Page 72

Installation and Programming Manual
3-46
AUTHORITY LEVEL DEGREE OF ACCESS GENERAL COMMENTS
Master
• all privileges of the Manager, but with
these restrictions:
• restricted to assigning and changing
User Codes belonging to those with
Authority Levels of Master and below
(i.e. User, Arm Only, and Maid)
• access to designated partitions
• there are no restrictions
in the number of Master
codes (as long as they
don’t exceed the number
of codes remaining in the
system)
User
• arming and disarming
• bypassing zones
• access to designated partitions
• viewing system status, trouble, and
alarm memory
• resetting the Switched Auxiliary
Output
• activating designated Utility Outputs
• specific control of
upload/downloading activities
• administering selected system tests,
except Walk Testing
• there are no restrictions
in the number of User
codes (as long as they
don’t exceed the number
of codes remaining in the
system)
Arm Only
• arming one (or more) partitions
• there are no restrictions
in the number of Arm
Only codes (as long as
they don’t exceed the
number of codes
remaining in the system)
• Arm Only codes are
useful for workers who
arrive when the premises
are already open but,
because they are last to
leave, they’re given the
responsibility to close
the premises
Maid
• used for one-time arming in one or
more partitions
• if first used to disarm the system, the
Maid code may be used once for
subsequent arming
• the Maid code is a
temporary code which
will be immediately
deleted from the system
once it has been used to
arm
• typically used
residentially for maids,
home attendants, and
repairmen who must
enter the premises
before the owner(s)
arrive
UO Only
• used to operate a Utility Output only
• typically used to enable
the operation of a device
controlled by a utility
output (i.e., a door, etc)
The activities in this section allow for:
• the assignment of Authority Levels
• the Partition assignment(s) for each User
Code
• viewing and re-assigning the Grand Master code
• choosing the Installer and Sub-Installer access
• codes, and determining the Code Length
With the display showing:
press [ENTER] to begin. The first sub-category, AUTHORITY, will appear on the display. You may access it by
pressing [ENTER], OR by pressing the [1] key.
INSTALLER PROG:
4)CODE MAINT. ↓