Installation and Programming Manual 3-47
CODE MAINTENANCE: AUTHORITY
CODE MAINTENANCE: PARTITION
Quick Key Item Default Explanation
4 1 AUTHORITY USER used for designating the Authority Level for each of
the 98 User Codes (which excludes the Grand Master
code–whose Authority Level is fixed)
the programmable Authority Levels are:
Manager, Master, User, Arm Only, and Maid
from the above display:
1. use the UP- or DOWN-arrow keys to position the cursor
under the first digit of the User Code to which you wish
to assign an Authority Level
2. enter the appropriate two-digit User Code
3. with the cursor positioned under the Authority Level, use
either [STAY] or [ARM] to select the Authority Level
intended for the designated User Code
4. press [ENTER] to advance to the next User Code, or
press the [.] key to return to the previous level
4 2 PARTITION
PARTITION
1
used to assign the partition(s) in which all User
Codes (except for the Grand Master) will operate
from the above display:
1. use the UP- or DOWN-arrow keys to position the cursor
under the first digit of the User Code to which you wish
to assign access to one (or more) Partition(s)
2. enter the appropriate two-digit User Code and
press [ENTER]
3. from the above display, designate the partition(s) for
which the designated user may have access by using
the [STAY] key to toggle between YES (Y) or NO (),
and either the [STAT] or [BYP] keys to move the
cursor left or right, respectively, as you make your
choices; note that “non-partitioned” system are
considered to use “Partition 1”
4. press [ENTER] to access another User Code
5. repeat steps 1 through 5, as required, until all
User Codes used in the system are assigned to the
appropriate partition(s)
6. when done, press the [.] key to return to the previous
level
CODE AUTHORITY:
CODE=01:USER
CODE PARTITION:
CODE=01:USER
P=12345678 C=xx
Y.......
INSTALLER PROG:
4)CODE MAINT.
↓
To Next Page
Loading...
