Installation and Programming Manual 3-53
DIALER: ACCESS & ID
Quick Key Item Default Explanation
5 4 ACCESS AND ID --- specifies the Access and ID Codes required for
successful remote communication (using RISCO
Group’s Upload/Download software) between the
Alarm Company and the Installation
5 4 1 Access Code 5678 select a 4-digit Access Code which will be stored in
the Pro-24
this same code must subsequently be entered into
the corresponding account profile created for the
installation in the Upload/Download software
for successful remote communication to take place
between the Alarm Company and the Installation, this
Access Code (along with the ID Code, see below),
must match
although it’s not required, it may be best to select a
different 4-digit Access Code for each installation.
5 4 2 ID code 0001 the ID Code can be thought of as an extension of the
Access Code, above
this same ID Code must subsequently be entered
into the account’s profile in the Upload/Download
software
for successful remote communication to take place
between the Alarm Company and the Installation, this
ID Code (along with the Access Code, see above),
must match
some dealers use the customer’s Central Station
Account Number for the ID Code, but any 4-digit code
unique to the installation will suffice
5 4 3 MS Lock 000000 MS Lock is a security function used in conjunction
with RISCO Group’s Upload/Download Software
(Version 2.3 or greater)
through the software, it is designed to provide
greater proprietary security when viewing several
Central Station parameters
it is NOT necessary to change the MS Lock default
value within Installer Programming; instead, the
procedure may be performed from the
Upload/Download Software and then downloaded
to the Pro-24
for additional information, refer to the
Upload/Download Programming Manual
INSTALLER PROG:
5)DAILER
↓
To Next Page
Loading...
