Installation and Programming Manual
3-60
DIALER: ALARM RESTORE
Quick Key Item Default Explanation
5 8 ALARM RESTORE
---
• specifies under what conditions an
Alarm Restoral will be reported
• such reporting informs the Central Station that
the specified condition(s) which occurred during
the alarm has changed
• if Restoral reports are to be sent, they have to be
assigned a valid reporting code (see the
Reporting Codes section on page 3-63)
for each of the three reporting options below, use the UP-or DOWN-arrow keys to scroll to the
desired choice and press [ENTER]
5 8 1
On BTO
Not for UL Installations
Report the restoral after the audible alarm “times out”
(BTO=Bell Time Out)
5 8 2
Follow Zone
report the restoral when the zone responsible for the alarm
returns to its non-violated (secured) state
5 8 3
At Disarm
report the restoral when the system (or the partition in
which the alarm occurred) is disarmed–even if the sounder
has already “timed out”
INSTALLER PROG:
5)DAILER
↓
To Next Page
Loading...
