Installation and Programming Manual 3-63
6) Report Codes
This section provides you with the opportunity to program the codes that will be transmitted by the Pro-24 when it
has events to report (e.g. alarms, troubles, restores, supervisory, and tests, etc.) to the Central Station. Note the
following:
• The codes specified for each type of event transmission are a function of the Central Station’s own policies.
Before programming any codes for the following events, be sure to check with them to make sure you
understand their protocols.
• While most Communication Formats (see page 3-52) support the Reporting Codes programmed on the
following pages–some do not. Check with the Central Station monitoring your Pro-24 accounts to determine
if the Communication Format being used requires such programming.
• As an example, the ADEMCO Contact (Point) I.D. and SIA formats support their own reporting code
allocations. If either of these formats is used, the programming steps found in this section become
unnecessary.
• Using a “double-zero” (00) for any event will prevent a report from being generated.
The following table provides instructions for programming the many event codes supported by the Pro-24. With the
display showing:
Quick Key Item Default Explanation
6 1 EMERGENCY
KEYS
---
• used to define the codes transmitted to the
Central Station when an alarm is sent (i.e. Police,
Fire, and Auxiliary emergency) via a keypad’s
Emergency Keys
• use the keypad’s (0-9) keys to enter the
designated code
• if necessary, use the UP- or DOWN-arrow keys to
reposition the cursor
• press [ENTER] to complete the process
6 1 1
Alarm
---
below, enter the 2-digit code for each of the
keypad-generated
alarms
if this event is not to be transmitted, use the “00”
default
6 1 1 1
Auxiliary emergency
00 for reporting a keypad-generated Auxiliary Emergency
6 1 1 2
Panic
00 for reporting a keypad-generated Police Emergency
6 1 1 3
Fire
00 for reporting a keypad-generated Fire Emergency
6 1 1 4
Duress
00
for reporting a keypad-generated Duress Emergency
(consult the Pro-24’s User’s Manual )
6 1 2
Restore
---
below, enter the 2-digit code used to report a restoral,
if desired, of the above keypad emergencies
6 1 2 1
Auxiliary emergency
00
for reporting the restoral of a keypad-generated
Auxiliary Emergency
6 1 2 2
Panic
00
for reporting the restoral of a keypad-generated
Police Emergency
6 1 2 3
Fire
00
for reporting the restoral of a keypad-generated
Fire Emergency
6 1 2 4
Duress
00
for reporting the restoral of a keypad-generated
Duress Emergency
INSTALLER PROG:
6)REPORT CODES¤
INSTALLER PROG:
6)REPORT CODES
↓
press [ENTER] to begin. The first sub-category, EMERGENCY KEYS will
appear on the display. You may enter it by pressing [ENTER] OR by pressing
the [1] key.
To Next Page
Loading...
