Installation and Programming Manual
3-72
6 8 6
00 report code used when the system is manually reset
using the Pro-24’s DEFAULT (J2) jumper
Abort Alarm --- press [ENTER]
6 8 7
00 report code used when the system sends an ABORT
message to the Central Station [see abort alarm in
system control for additional details]
Self-Test OK --- press [ENTER]
6 8 8
00 report code used when the system sends a
confirmation of a successful “Zone Self-Test”
[see page 3-32 for additional details]
Self-Test Failure --- press [ENTER]
6 8 9
00 report code used when the system sends a
verification of an unsuccessful “Zone Self-Test”
[see page 3-32 for additional details
Cancel Report --- press [ENTER]
6 8 0
00 report code used when the system sends a user-
initiated cancellation of an alarm in progress
[see the Pro-24 User’s Manual for additional details]
6 9 SPECIAL
COMMUNICATION
---
• use this area to supply any converted codes
which are necessary for those Central Station
Communication Formats requiring 3-digit Event
Codes
• refer to the Pro-24 Installer Programming
Worksheets for additional information
• press [ENTER] to begin
To Next Page
Loading...
