Risco Pro-24 - Page 99

Installation and Programming Manual 3-73
REPORT CODES: ACCESSORY CODES
Quick Key Item Default Explanation
6 0 ACCESSORY CODE
Not for UL
Installations
---
• use this area to supply the reporting codes
governing the operation of these system Pro-24
accessories:
• Wireless Zone Expansion Module
• Wireless Button Module
• Wireless Button
• Printer Module
• press [ENTER] to begin
6 0 1
Wireless Zone
Expander
---  press [ENTER] to access each sub-category, below
6 0 1 1 Jamming Trouble 00
 enter the Wireless Zone Expander’s 1-digit physical
I.D., along with the 2-digit report code used to
represent the module’s detection of “jamming”
interference, according to the parameters established
on page 3-15
6 0 1 2
Jamming Trouble
Restore
00
 enter the Wireless Zone Expander’s 1-digit physical
I.D., along with the 2-digit report code used to
represent the restoral-to-normal of the detection of
interference, above
6 0 2
Wireless Button
Module
---  press [ENTER] to access each sub-category, below
6 0 2 1 Jamming Trouble 00
 using either the UP- or DOWN-arrow keys, enter the
Wireless Button Module’s 1-digit I.D., along with the
2-digit report code used to represent the module’s
detection of “jamming” interference, according to the
parameters established on page 3-15
 if this event is not to be transmitted, use the “00”
default
 press the [/] key to return to the previous
programming level
6 0 2 2
Jamming Trouble
Restore
00
 using either the UP- or DOWN-arrow keys, enter the
Wireless Button Module’s 1-digit I.D., along with the
2-digit report code used to represent the restoral-to-
normal of the detection of interference, above
 if this event is not to be transmitted, use the “00”
default
 press the [/] key to return to the previous
programming level
INSTALLER PROG:
6)REPORT CODES
↓