162 ProSYS Installation and Programming Manual
Accessories: Add Delete Module
Quick Keys Parameter Default Range
NOTE:
You can define two printers in the system, but both printers cannot print the same
events.
1. Press / to store your choice and to repeat the process
if there is a second Printer module in the system.
2. Press
to return to the previous programming level.
If a Printer module is found and NONE has been selected, the following
display appears:
3. Press / to return to the prior display,
-OR-
Press the
/ key to select [Y] YES and press /
to confirm the delete.
4. Press / to begin. The only sub-category, WIRELESS
BUTTON ALLOCATION, appears on the display. You may enter it by
pressing
/ OR by pressing the [1] key.
77
11
88
Access Control
1. Press [8]. The following display appears:
2. Use the / or / keys to position the cursor in
the ID=1 field and type in the Access Control module's ID number as
defined by the dip switches that you set when you installed the module.
3. If required, position the cursor in the TYPE field and use the
/
key to toggle and choose the AC option.
4. Press
/ to add the Access Control module.
NOTES:
Each Access Module has fixed numbering for the doors and the readers. For
example, Access Module #1 is for doors 1 and 2; Access Module #2 is for doors 3
and 4, and so on.
5. Toggle the / and / keys to select the
appropriate number of doors and readers that you want to define, as
described in the following options and then press
/ :
 Select 1 door, 1 reader to initialize one door, and then proceed
to step 7.
 -OR-
 Select 1 door, 2 readers to initialize one door, and then proceed
To Next Page
Loading...
Need help?
General
