What to do if a paper jam has occurred on the Paper Receiving Tray section of Riso Disc Duplicator?
If a paper jam has occurred on the Paper Receiving Tray section of your Riso Disc Duplicator, remove the jammed paper from the Paper Receiving Tray section. If the error indications persist, press the key.
What to do if a paper jam has occurred on the Paper Feed Tray section of Riso Disc Duplicator?
If a paper jam occurs on the Paper Feed Tray section of your Riso Disc Duplicator, first remove the jammed paper. Then, set the paper again. If the error indications do not disappear, press the key.
How to fix a paper jam in the ADF unit of a Riso Disc Duplicator?
If a paper jam has occurred in the ADF unit (option) of your Riso Disc Duplicator, remove the original jammed in the ADF unit. You can remove it in the document insertion direction by pressing the ADF Original Release Button and pulling out the original. Alternatively, you can open the Stage Cover and remove it in the document output direction by turning the ADF Original Release Dial while pulling out the original.
What to do if a paper jam has occurred around the Print Cylinder of Riso Disc Duplicator?
If a paper jam has occurred around the Print Cylinder(Drum) of your Riso Disc Duplicator: 1) Pull out the Print Cylinder(Drum). 2) If you find jammed paper, remove it.
What to do if a master has not been sent to the Master Disposal Box of Riso Disc Duplicator?
If a master has not been sent to the Master Disposal Box in your Riso Disc Duplicator: 1) Pull out the Print Cylinder(Drum) and remove the master on the cylinder(drum). 2) Set the Print Cylinder(Drum) again. 3) Press the key.
What to do if a master issue has occurred in the master disposal section of Riso Disc Duplicator?
If a master issue has occurred in the master disposal section of your Riso Disc Duplicator: 1) Remove the Master Disposal Box. 2) Stand and push down the Master Release Lever at the inside of the Master Disposal Box.
What to do if a master has not been correctly cut in Riso Disc Duplicator?
If a master has not been correctly cut in your Riso Disc Duplicator: 1) Remove the master roll and close the Master Making Unit Cover. 2) Set the master again.
General| Brand | Riso |
|---|---|
| Model | RZ310UI |
| Category | Disc Duplicator |
| Language | English |
To Next Page
