• Your thermostat is a precise instrument, handle it with care.
• Turn off electricity to the appliance before installing or
servicing thermostat or any part of the system.
• Do not turn electricity back on until work is completed.
• Do not short (jumper) across electric terminals at control on
furnace or air conditioner to test the system. This will damage
the thermostat and void your warranty.
• All wiring must conform to local codes and ordinances.
• This thermostat is designed for use with 24 volt AC and
millivolt systems. The thermostat should be limited to a
maximum of 1.0 amps; higher amperage may cause damage
to the thermostat.
Caution
Install guide 6022
ENGLISH
HEAT
T
ARGET TEMP
PROGRAM
HOLD
COPY
REVIEW
FIL
TER
TIME SLOT
TIME SET
SET
CLOCK
EP
A
PROG2
To Next Page
Need help?
General
