To Next PageTo Next Page
Need help?Do you have a question about the Rittal AX Series and is the answer not in the manual?
General| IK Code | IK10 |
|---|---|
| Surface finish | Powder coated |
| Mounting plate | Yes |
| Mounting Type | Wall mounting |
| Door Options | Single door, Double door |
| Cooling Options | Fan, Air/water heat exchanger |
| Accessories | lighting |
Declaration of conformity according to DIN EN 62 208 available for download.
Safety notes and accompanying notes must be given to the plant operator for storage.
Instructions indicate that safety notes are documented on pages 12-16.
Assembly and operating instructions for enclosures can be downloaded from Rittal.
Rittal AX enclosures conform to technical regulations for various markets and applications.
Defines the proper application and limitations of the enclosures for low-voltage switchgear.
Key warnings regarding moving parts, loads, and installation safety.
Describes the AX compact enclosure's suitability for electrical, electronic, mechanical equipment.
Mounting plate, door, body, and rating plate have QR codes with component-specific data.
Notes that the door and mounting plate are supplied loose and pins are not fitted.
Lists components included with sheet steel enclosures featuring cam locks.
Lists components included with sheet steel enclosures featuring locking rods.
Defines ambient temperature, humidity limits, and condensation prevention for installation.
Describes enclosure placement options and hinge swapping for 1-door models.
Describes enclosure placement options for 2-door models.
Instructions for mounting doors with right-side hinges on 1 or 2-door enclosures.
Instructions for mounting doors with left-side hinges on 1 or 2-door enclosures.
Procedure for safely removing the enclosure door.
Procedure for replacing the locking rod mechanism on left-hinged enclosures.
Steps for installing and removing cam lock mechanisms on enclosures.
Guidance on inserting sealing bungs into the enclosure's pre-drilled holes.
Instructions for mounting the gland plate, noting it's not for active components.
Procedure for installing the mounting plate in enclosures with cam locks.
Procedure for installing the mounting plate in enclosures with locking rods.
Steps for earthing the enclosure, door, and mounting plate.
Details on preparing doors and housing for earth straps and automatic potential equalization.
Advice on preventing dust/humidity ingress and ensuring doors are properly closed.
Table detailing IP and IK ratings, and NEMA types for various enclosure models.
Provides heat loss values (Watt) for different enclosure models at a specific temperature delta.
