MIDI Usage
The Mini Amp Gizmo can receive MIDI messages from any MIDI
controller. You can store different switch settings for MIDI program
numbers 1 through 128 in MIDI banks 0 and 1. When a Program
Change message is received on the correct channel, the Mini Amp
Gizmo will automatically recall the saved settings for the given
program number.
To set up for MIDI use, simply connect your MIDI controller to your
Mini Amp Gizmo’s MIDI In jack. The Mini Amp Gizmo is set for MIDI
Channel 1 by default. Either make sure your MIDI controller is set up
to transmit commands on Channel 1, or use the Mini Amp Gizmo’s
setup mode to change which MIDI channel the Mini Amp Gizmo
responds to. See the Setup Mode section for more details.
To save a program setting, perform the following steps:
1. Using your MIDI controller, select a MIDI program number.
2. Using the Mini Amp Gizmo buttons, select your amp’s
channel and functions.
3. Hold down the Write button on the Mini Amp Gizmo until
the LEDs flash. This should take about 3 seconds.
That’s all it takes. You can repeat this for any or all of MIDI program
numbers 1 though 128.
If the lights don’t flash after a few seconds of holding down the Write
button, it means that your Mini Amp Gizmo did not receive the MIDI
Program Change message. Check your MIDI cable connection, and
make sure that the MIDI controller and Mini Amp Gizmo are set to
the same MIDI channel.
Now that your settings have been saved, you can recall your settings
by using your MIDI controller to send a Program Change message
again. The Mini Amp Gizmo will call up your saved settings and set
To Next Page
Loading...
Need help?
General
