Saving MIDI Channel and Options
Once you’ve set the MIDI channel and options, press the Write
button. The Mini Amp Gizmo is now in normal operational mode.
Invert Mode
Some amplifiers may have inverted polarity on some functions. This
can cause the Mini Amp Gizmo to display a function as off when the
function is actually on, and as on when the function is actually off. To
correct this, you must first switch the Mini Amp Gizmo to invert
mode.
Hold down the Switch 2 button while powering up the Mini Amp
Gizmo. Keep holding the button until the LEDs flash. You are now in
invert mode.
While in invert mode, use the front panel buttons to light the LED of
any function that is inverted. Make certain no other LED is lit.
Once you’ve selected the inverted function’s associated button(s),
press the Write button. The Mini Amp Gizmo is now in normal
operational mode, and the inverted functions should operate
correctly.
Momentary Mode
Some devices require momentary-type switching, rather than the
more common latching-type switches. (A momentary switch
changes OFF/ON state by closing its contacts for a short time and
then re-opening them. In momentary mode, the Mini Amp Gizmo
switches will close for 100 milliseconds before opening again.)
To Next Page
Loading...
Need help?
General
