To enter momentary mode, hold down the Switch 3 button while
powering up the Mini Amp Gizmo. Keep holding the button until the
LEDs flash. Use the front panel buttons to light the LED of any
function that needs to be momentary. Make certain that no other
LED is lit.
Once you’ve selected the buttons for the momentary functions, press
the Write button. The Mini Amp Gizmo is now in normal operational
mode and the momentary functions should operate correctly.
Group Mode
The group mode feature allows you define a group of buttons where
pressing one button of the group turns that button on and turns all
other buttons in the group off. This is typically used for switches that
control which channel is selected on an amplifier. This prevents the
Mini Amp Gizmo from trying to activate more than one amp channel
at a time.
To enter group mode, hold down the Switch 4 button while
powering up the Mini Amp Gizmo. Keep holding the button until the
LEDs flash.
Use the front panel buttons to light the LED of any function that
should be in the group. Make sure that no other LEDs are lit.
Once you’ve selected the functions that need to be grouped, press
the Write button. The Mini Amp Gizmo is now in normal operational
mode and the grouped buttons will now only allow one button to be
selected at a time.
Quick Setup Buttons
Quick Setup buttons are provided to quickly set up the Mini Amp
Gizmo for common configurations. Which configuration you use
To Next Page
Loading...
Need help?
General
