depends on the number of channels your amplifier has, and whether
the amplifier uses momentary switching or not.
To use this feature, hold down the Switch 8 button while powering
up the Mini Amp Gizmo. Keep holding the button until the LEDs all
turn on and stay on.
Next, press one of the following buttons. Based on the button
pressed, the Mini Amp Gizmo will configure the switches as follows:
Switch 1: No switches momentary or grouped. (Default setting)
Switch 2: First two switches grouped, no switches momentary. (Most
2 channel amps)
Switch 3: First three switches grouped, no switches momentary.
(Most 3 channel amps)
Switch 4: First four switches grouped, no switches momentary. (Most
4 channel amps)
Switch 5: All switches momentary, none grouped. (Rivera M and S
amps)
Switch 6: First two switches grouped and momentary.
Switch 7: First three switches grouped and momentary. (Bogner
Ecstasy, EVH 5150III)
Switch 8: First four switches grouped and momentary. (Marshall
Mode 4)
Once the button has been pressed and the LEDs have flashed, the
Mini Amp Gizmo will go directly to normal operating mode.