*Setup Mode can be used to change which Continuous Controller
messages the Mini Amp Gizmo responds to. Please refer to the Setup
Mode section for more details.
Please note that settings such as Momentary Mode and Group Mode
are in effect when processing Continuous Controller messages.
Bank Selection
The Mini Amp Gizmo can store programs in MIDI banks 0 and 1, for a
total of 256 programs. Continuous Controller #0 (Bank MSB) is used
to select the current MIDI bank. Bank numbers above bank 1 are
ignored.
By default, bank selection is disabled. You can enable bank selection
using Setup Mode (see Setup Mode section).
Backing Up Your Settings: SysEx Dump
A SysEx (System Exclusive) data dump will send the current Mini Amp
Gizmo system configuration out through the MIDI Thru/Out port.
You can then save this data to your computer, or copy the settings
directly to another Mini Amp Gizmo.
Hold down the Switch 5 button while powering up the Mini Amp
Gizmo, and the Mini Amp Gizmo will immediately send the SysEx
Dump. It only takes a couple of seconds to complete.
If you wish to copy settings from one Mini Amp Gizmo to another,
connect the MIDI Thru/Out of the transmitting unit to the MIDI Input
of the receiving unit, then power up the transmitting unit while
holding down the Switch 5 button. (Note that the receiving Mini
Amp Gizmo must be powered on and not in setup mode.) The
receiving unit will display a progress bar graph on the LEDs. The
transfer goes very quickly, taking only a couple of seconds. In the
case of an error, the receiving unit will flash all LEDs 5 times.
To Next Page
Loading...
Need help?
General
