15
Use this “Y” to connect more than one 12 volt accessory to a single 12 volt outlet.
This easy-to-install kit prevents the brake signal from over-riding the turn signal of a towed
vehicle. It is necessary to install this kit on many vehicles with add-on braking systems that
depress the car’s brake pedal and will not interfere with the car’s electronics when the ignition
is on. See “Brake -Lite Relay Kit” install instructions later in this manual.
Kit includes:
• All wires and components needed • Easy to follow instructions
Optional Equipment
12 Volt “Y’’- # 9330
Brake-Lite Relay Kit - #88400
This extension cord will extend your 12 volt outlet by 6 feet.
12 Volt Outlet Kit wit h 5ft . Wire - # 9332
12 Volt Extension Cord - 6ft - #9331
Some models of cars have no power to the cigarette lighter when the ignition key is
off. The braking system cannot operate correctly with an outlet with less than 15
amps of power. Use this kit to create a new full time 12 volt, 20 amp power outlet.
The BrakeAway is an integral and necessary part of a safe towing experience. Since
the BrakeAway is hard wired into the car through the firewall, if you have a second
car it is recommended that you purchase a second kit to make your towing
experience safe and easy.
This option lengthens the reach of the braking system’s cylinder arm 1 1/2
inches. Threads between pedal clamp and cylinder arm.
3.5’’ Cylinder arm extender - #9336-3
This option lengthens the reach of the braking system’s cylinder arm 3 1/2
inches. Threads between pedal clamp and cylinder arm.
This option allows the braking system to sit higher in the vehicle. Threads into bottom
of the unit, then adjustable feet thread into extensions.
1.5’’ Cylinder arm extender - #9336
Second vehicle BrakeAway kit - #98162
Foot extender - #9337 1 ea. #9337-4 (4 pack)
To Next Page
Loading...
