Roadmaster CRUISER - Attach The Basket

3 Assembly
28
Figure 3.20
Figure 3.19
Figure 3.18
ATTACH THE BASKET
WARNING!
Failuretosecurelyaachthebaskettothebicyclemaycause
thebaskettofalloandcauseanaccidentresulnginserious
injuryordeath.Alwaysmakesurethebasketissecured
beforeriding.Donotcarrypetsinthebasketorloadsgreater
than10lbs.(4.5kgs).
Note:Notallbicycleswillcomeequippedwithbaskets
❶ Placethemounngbracketonthehandlebarssotheclamps
areoneithersideofthestemandthebasketplateisfacing
forward.Theboombraceshouldtsnugagainstthe
bicycle.Figure 3.18
❷Makesuretheclampshaveasnugtagainstthe
handlebars.Usetheshimsprovidedasneededtocreatethe
rightt.
❸ Alignclampholeswithmounngbracketholesandinsert
thescrews.Tightenallfourscrewsevenly.Figure 3.19
❹Toadjusttheangleofthebasket,usea4mmAllenwrench
ontheboltatthesideofthebracket.Onceadjustedtothe
correctangle,ghtentosecure.
❺Toaachthebasket,pushthebasketdownontothebasket
plateunlitclicksintoplace.Toremovethebasket,push
theredreleasebuonlocatedonthebasketbracketandli
thebasketup.Figure 3.20
Clamps
Screws
Basket
plate
Release
buon
3
1
2
4
5