[ Pitch Modulation
]
This section shows how you can alter the overall pitch of the sound, either using an LFO to change the pitch
over time (vibrato) or how much the pitch bend controller alters the pitch.
Pitch Modulation LFO
Amount
The amount of LFO modulation appli
ed. At the full amount, the pitch goes up / down by one semitone (
sine,
triangle
and
S&H
waves) & up only by one semitone for the square and saw waves.
Amount control
Here you can select the controller (for instance Modulation Wheel) that controls the
a
mount
of Pitch LFO
modulation. Listen to "Predator SyncLead" in the first bank.
The control amount can be set to positive as well as negative.
Speed
This controls how fast or slow the L.F.O is running.
Sync
If you turn sync
on
, the
speed
of the LFO will
be tempo based.
To find the correct setting you need to adjust the
speed
parameter.
Waveform
Sine, Triangle, Saw Up, Saw Down, Square
and
S&H
.
Sinus
and
Triangle
are most often used for pitch
because they produce a modulation that goes up and down smoothly. The other waveforms are more
suitable for FX sounds or special sounds.
Pitch bend
Down
This sets the pitch change when you move the pitch
-
bend wheel Down. It ranges from
Off
, down to
-
48
semitones (
-
4 octaves).
Up
This sets the pitch change when
you move the pitch
-
bend wheel Up. It ranges from
Off
, up to + 48 semitones
(+ 4 octaves).
To Next Page
Loading...