Rob Papen Predator - Wah;Delay, Distortion, and Filter Effects

47
Wah/Delay
This effect produces a wahwah type effect by running the sound through a lowpass -filter that s frequency is
changed over time. There is a built in delay which adds delays to the sound.
Low Range Lowest Frequency of the filter. Here you can adjust how deep the LP filter ranges. The more
you move the dial to the left, the lower the filter goes.
High Range Highest Frequency of the filter. Here you can adjust how high the LP filter goes.
The more you move the dial to the right, the higher the filter goes.
Speed The rate the filter frequency changes over time. Tempo based.
Resonance Controls the resonance of the used low - pass filter.
Delay Length of the wahwah delay. This delay is after the WahWah FX.
Feedback Amount the wahwah delay feeds back into the sound.
Delay Vol Volume of the delay.
Distort (distortion)
This distorts the audio by saturating, limiting, rectifying and bandpass filtering the input.
Limit Hard limiter threshold.
Rect Amount of rectification, from - 100% (no change), 0% half to 100% - full.
Distort Amount of Distortio n.
Tone Frequency of the band pass filter.
Emphasis Bandwidth of the band pass filter.
Post - Boost Amount the filter signal is boosted.
M- Wheel>Tone Amount the band pass filter frequency is changed by the modulation wheel.
Low - Fi
This effect reduce s the digital audio quality of the sound, which results in old style computer sound effects.
Bits Bit level of the signal.
Sample Rate Sample rate of the signal.
LP Filter Frequency of the low pass filter.
M- Wheel>Filter Amount the low pass filter fre quency is changed by the modulation wheel.
Amp Sim
Several types of amp types are simulated. Great for creating edgy sounds.
Type Type of amp simulation. Settings are: - None , 4x10" guitar speakers , 4x12" guitar speakers ,
Bass speaker , Combo speaker and Radio speaker .
The none speaker setting is useful if you want to only use the distortion in the FX effect.
Distort Amount of distortion added to the sound. Also works if the none speaker setting is selected.
Bass Bass EQ Volume. Adds or removes low end fr om the speaker simulator.
Treble Treble EQ Volume. Adds or removes high frequencies from the speaker simulator.
Volume Volume boost. Adjusts the volume of the processed sound.
Note : with the Amp simulator FX it is recommended to fully open the Mix control knob (wet).
WaveShaper
The waveshaper effect shapes the in - going sound to a kind of distorted version of it.
It is then passed through a low pass filter which its frequency is changed over time by a tempo based LFO.
Top Amt The amount positive input is waveshaped.
Bottom Amt The amount negative input is waveshaped.
Rect The amount the sound is rectified, at - 100% the sound goes through as normal, at 0% no
negative output is heard and at 100% any negative output is made positive.
Filter Low pass filter f requency. This filter does not filter the high frequencies.
LFO Amount The amount the low pass filter frequency can change.
LFO Speed The rate the low pass filter frequency can change.