Note: FX
Mix
sets how much of the Compressor FX is added. With the Compressor FX it is wise to fully open
the
Mix
control knob (wet).
Ensemble
This effect uses 6 choruses, each having its own
setting, to give the effect of several copies of the sound
playing at once.
Length
Length of the ensemble effect.
Width
Maximum change to
ensemble
length.
Speed
Speed the ensemble length changes.
Feedback
Feedback of the choruses.
Ensemble
Amoun
t the choruses differ from each other.
Spread
Amount the choruses are panned to the left or right.
Cabinet
Several types of cabinet types are simulated. Great for creating edgy sounds.
Type
Type of cabinet simulation. Settings are:
-
None, Fende
r, Marshall &
Off Axis. The none
speaker setting is useful if you want to only use
the distortion in the FX effect.
Distort
Amount of distortion added to the sound. Also works if the none cabinet setting is selected.
Bass
Bass EQ Volume. Adds or removes low end from the cabinet simulator.
Treble
Treble EQ Volume. Adds or removes high frequencies from the cabinet simulator.
Volume
Volume boost. Adjusts the volume of the processed sound.
Note: with the Amp simulator FX it is recommended to fully open the Mix control knob (wet).
MultiDistort
Allows you to use several different types of distortion effects
Type
Different type of distortion allowed, they are
None, Atan, Cos, Cross, Foldover, Fuzz, Limiter, Overdrive, Power, Rectifier, Saturator,
Square,
None means no distortion is used
Pre
-
boost
How much the signal is boosted before going into the distortion
Amount 1
Control how much the signal is distorted
Amount 2
Additional distortion parameter for Fuzz
Normalize
How much the output volume is normaliz
ed to the input volume, at
100% the output volume
should be the same as the input volume.
Low Filter
Post distortion low
-
pass filter
High Filter
Post distortion high
-
pass filter
Post
-
Boost
How much the output of the distortion is boosted.
AutoWah
Autowa
h uses a low/bandpass filter to filter the signal using the volume of signal to alter the frequency of the
filter.
Type
Type of auto
-
wah filter, lowpass or bandpass
Low Frequency
Lowest frequency of auto
-
wah filter
High Frequency
Highest frequency of aut
o-
wah filter
Amoun
t
How much the volume of the signal alters the filter's frequency
Q
Resonance / Bandwidth of autowah filter
Smooth
How much signal volume is smoothed.
To Next Page
Loading...