Mode
Poly
,
Free
and
Mono.
Thi
s controls how the LFO responds when you hit one or more keys.
Poly mode
:
Each note you play has its own Filter LFO and each LFO starts from the zero position.
Poly mode is useful for complex sounding Filter LFO modulation.
Free mode
:
The LFO is free r
unning and all the notes share the same LFO. The LFO is always
running and does not reset when you press a key.
Mono mode
:
Similar to free mode All the filter LFO s have the same value, however when you press
a key in Mono mode, all LFO s are reset to th
eir initial start position.
Destination LFO 1
This is where you can select the destination of the LFO 1 modulation.
Listen to preset "Hipass arp" in the first bank. In this preset the
Filter2 Cutoff frequency
is modulated by
LFO1.
Destination amount LFO
1
This is where you can select the amount of LFO1 changes the LFO 1 destination control.
This can be a positive or negative modulation depending on the selected parameter.
Listen to preset "Hipass arp" in the first bank. In this preset the
Filter2 Cutoff
frequency
is modulated.
Increase or decrease the amount to listen to what it does.
Amount control LFO1 destination
This is where you can adjust how much LFO 1 s amount is changed by the modulation source and also
which modulation source is used.
This
can be a positive or a negative amount. So you can increase the modulation or decrease the
modulation.
Look at preset "Hipasser arp" in the first bank as an example. You can see that in this preset the Mod.Wheel
is addressed with
-
81% amount.
So if you op
en the Mod.Wheel the LFO 1 modulation inside the destination will be less.
In fact with a fully open Mod.Wheel the LFO 1 does not modulate the destination anymore.
This happens because the LFO 1 destination amount is 81% and the modulation control is se
t to
-
81%.
Destination LFO 2
This is where you can select the destination of the LFO 2 modulation.
Listen to the preset "Hipass arp" in the first bank. In this preset the Amp panning is modulated by LFO2.
Destination amount LFO 2
This is where you can s
elect the amount of LFO2 changes the LFO 2 destination control.
This can be a positive or a negative modulation depending on the selected parameter.
Listen to the preset "Hipass arp" in the first bank. In this preset the Amp panning is modulated. Increase
or
decrease the amount to listen to what it does.
To Next Page
Loading...