Roberts Blutune 40 - Setting the Clock Manually

If you need any further advice, please call our Technical Helpline on :-
020 8758 0338 (Mon-Fri)
30
Setting the clock manually
Normally your radio will set its clock automatically using the DAB radio
signal. If no DAB signal is available and you need to set the time manually,
please follow the procedure shown below.
1. Press and release the On/Off button to switch on the radio.
2. To set the clock time, press and release the Menu button until the
advanced menu shows on the display.
3. Rotate the Tuning control until 'SYSTEM' appears on the display.
Press and release the Tuning control.
4. Rotate the Tuning control until 'TIME' appears on the display. Press
and release the Tuning control.
5. Rotate the Tuning control until 'SET TIME' appears on the display.
6. Press and release the Tuning control to enter the manual setting
procedure. The hour digits will then fl ash on the display.
7. Rotate the Tuning control to set the desired hour.
8. Press and release the Tuning control to enter the hour setting.
9. The minute digits will then fl ash on the display. Rotate the Tuning
control to set the desired minute.
1
2
3-9