If you need any further advice, please call our Technical Helpline on :-
020 8758 0338 (Mon-Fri)
16
Scan sensitivity setting - FM
Your radio will normally scan for FM broadcasts which are strong enough
to give good reception. However, you may wish the Auto-scan function
to also be able to fi nd weaker signals, possibly from more distant radio
transmitters. Your radio includes a local / distant option for the Auto-scan
function.
1. Press and release the On/Standby button to switch on your radio.
Ensure your radio is in FM mode.
2. Press and release the Menu button. The FM menu will show on the
display.
3. Rotate the Tuning/Select control until 'SETTING' shows on the display.
Press and release the Tuning/Select control to enter the scan settings
menu.
4. Rotate the Tuning/Select control to switch between Local and Distant
options. The Distant option will allow the radio to fi nd weaker signals
when scanning.
5. Press and release the Tuning/Select control to confi rm your selection.
The display will return to the radio display after several seconds. The
Local or Distant setting is stored in the radio and remains in force until
changed or until a System Reset.
Note: The initial setting (out of the box, or after a System Reset) causes
the radio to ignore weaker (or more distant) signals.
1
3-5
2
To Next Page
Loading...
