13
Operating your radio - FM
1. Carefully extend the telescopic aerial. The aerial should be fully
extended and positioned vertically for optimum reception.
2. Press and release the On/Off button to switch on your radio.
3. If you are listening in DAB mode, press and hold the Mode button.
'FM' will show on the display.
4. Rotate the Tuning/Select control clockwise and then immediately
press and hold the Tuning/Select control for several seconds.
Your radio will scan in an upwards direction (low frequency to
high frequency) and stop automatically when it fi nds a station of
suffi cient strength.
5. After a few seconds the display will update. The display will show
the frequency of the signal found. If the signal is strong enough and
there is RDS data present then the radio will display the station
name.
6. Rotate the Tuning/Select control anti-clockwise and then
immediately press and hold the Tuning/Select control for several
seconds. Your radio will scan the FM band in a downwards direction
(high frequency to low frequency).
7. When the waveband end is reached your radio will recommence
tuning from the opposite waveband end.
8. Adjust the Volume to the required setting.
9. To switch off your radio press and release the On/Off button.
2,9
3
4-6
8
8
To Next Page
Loading...
