11
Operating your radio - DAB
1. Carefully lift the antenna and position it vertically.
2. Press the On/Off button to switch on your radio.
The display will show ‘Welcome to Digital Radio’.
3. If this is the fi rst time the radio is used a scan of
the Band III DAB channels will be carried out.
If the radio has been used before the last used
station will be selected.
4. During the scanning process, the lower line of the
display shows a bar-graph indicating progress
of the scan.
5. When the scanning is completed the fi rst station
(in numeric-alpha order 0...9...A....Z) will be
selected. Your radio will automatically set to the
current time.
6. If the station list is still empty after the scan your
radio will display ‘Service not available’.
7. If no signals are found it may be necessary to
relocate your radio to a position giving better
reception. Then, either switch your radio off
and on again, or follow the procedure page 19
to repeat the scan.
To Next Page
Loading...
