37
2. Press the numbered buttons to set the alarm on time. e.g. to set an
alarm time of 13:30, press the buttons "[1] [3] [3] [0]". If a wrong
number was keyed in, pressing the "C" button will delete one digit
for each press. Press the "Enter" button, the display will show "13:30"
and "Standby" will stop flashing indicating that the alarm has been
set to 13:30.
If the time keyed in is not valid i.e. 25:30, the display will show "E" for
about 2 seconds and then revert to showing real time.
To Next Page
Loading...
