Finding new stations - DAB
Should you wish to use your radio for DAB reception in a new location,
or if no stations were detected during the initial scan, you can follow this
procedure to allow your radio to find out which DAB radio stations are
available.
1. Ensure that the telescopic antenna is extended, and then repeatedly
press the Mode button until the radio is in DAB mode.
2. Once in DAB mode press and release the Menu button.
3. Rotate the Tuning/Select control until "Local scan" is highlighted on
the display.
4. Press and release the Tuning/Select control and the display will show
"Scanning". Your radio will perform a scan of the UK DAB frequencies.
As new stations are found the station counter on the right hand side
of the display will increase and stations will be added to the list.
5. To carry out a full scan of the entire DAB band III frequencies rotate the
Tuning/Select control until "Full scan" is highlighted on the display.
6. Press and release the Tuning/Select control and the display will show
"scanning". As new stations are found the station counter on the right
hand side of the display will increase and stations will be added to the
list.
3,4
2
43
1
WM-202 iss 1.indd 44 20/02/2008 13:03:58
To Next Page
Loading...
