3. Press Press
To change
Temperature Differential*
*T
HE TEMPERATURE DIFFERENTIAL IS FACTORY PRESET AT 1°. THIS MEANS
THAT WHENEVER THE ROOM TEMPERATURE CHANGES BY ONE FULL DEGREE FROM
THE TEMPERATURE SETTING
, THE SYSTEM WILL TURN ON. IF THE SYSTEM TURNS
ON TOO OFTEN
, INCREASE THE TEMPERATURE DIFFERENTIAL.
4. Press Press
To change
Residual Cooling**
**THE RESIDUAL COOL FEATURE WILL KEEP THE SYSTEM FAN ON FOR AN ADDITIONAL 30, 60 OR 90
SECONDS AFTER THE COMPRESSOR CYCLES OFF. RESIDUAL COOLING CAN ONLY BE PROGRAMMED WHEN
SETTING THE COOLING PROGRAM
.
Changing Fahrenheit (F) to Celsius (C)
Press and Hold SET Press
Release both simultaneously.
QuickSet™ Programming Mode*
1. Place COOL-OFF-HEAT
in HEAT or COOL position.
2. Press & Hold SET. Press the d button.
Release simultaneously.
3. The MORN indicator should be blinking. Program the Time-of-Day and
the temperature as outlined in the Setting Daily Program section.
*QuickSet™ will program all 7 days of the week with the same program.
Individual days can then be changed or modified.
6
To Next Page
Loading...
