3. Press PROG/MAN button
until indicator is in PROG position.
Temporary Program Override
To temporarily increase or decrease temperature
Press c or d
The Thermostat will automatically return
to the program at the next scheduled
setting change.
Manual Operation
1. Press PROG/MAN until indicator is in MAN position.
2. Press c or d to adjust
temperature settings.
Reset
To Reset the thermostat to factory pre-programmed
conditions, press the reset button located directly
above the wiring terminal block.
8
NOTE: W
HILE IN THE
C
OOL MODE
, (
OR HEAT AND COOL FOR SINGLE STAGE HEAT PUMP SYSTEM
)
ONCE THE THERMOSTAT
TURNS THE SYSTEM OFF
,
A BUILT
-
IN DELAY KEEPS THE COMPRESSOR FROM TURNING ON FOR ABOUT
5
MINUTES
. T
HIS PRO
-
TECTS THE COMPRESSOR
. N
O ADDITIONAL TIME DELAY RELAY
(
DELAY ON BREAK
)
IS NECESSARY
. T
OP OVERRIDE THE
5-
MINUTE
DELAY FOR INSTALLATION
,
PRESS
RESET. T
HIS WILL ERASE THE DELAY AND CHANGE PROGRAMMING TO FACTORY PRE
-
SETS
..
To Next Page
Loading...
Need help?
General
