will change the setpoint. The heat or cool mode should be
selected.
Schedule Overrides
When the thermostat is running to a schedule, an override allows the
thermostat to function with a single setpoint for a time period.
A temporary override is entered as a setpoint for a number of hours.
TTeemmppoorraarryy OOvveerrrriiddee
1. Press or to display the flashing setpoint and the number of
hours.
2. Use and to change the setpoint.
3. Press SET TIME to move to the hours.
4. Use and to set the length of the override.
After 5 seconds the thermostat will start operation of the override. The
display will show room temperature, and the setpoint will alternate with
the number of hours remaining in the override.
The schedule will resume after the programmed hours expire. Heat or
Cool must be selected. Cancel the override by pressing START/STOP
SCHEDULE.
Origin of Setpoint
When the thermostat is using a schedule the temperature setpoint
originates from the schedule settings.
When one of the schedule overrides is active the setpoint has been
entered as part of the override.
Use the display to determine the origin of the current temperature
setpoint.
Permanent Override - The day, time and “schedule” are not displayed.
12
To Next Page
Loading...
Need help?
General
