Robertshaw RS8210 User Manual

Feature
Filter Change
Reminder
Room
Temperature
Calibration
Minimum
Compressor
On-Time
Compressor
Short Cycle
Delay
Cooling
Differential
Heating
Differential
Factory default
settings
OFF 0°F OFF On 0.5°F 0.4°F
Feature
Description
This setting will
ash FILT in the
display after the
elapsed run time
to remind the
user to change
the lter.
The OFF setting
will disable
this feature.
This setting
allows the
installer to
change the
calibration
of the room
temperature
display so that,
for example,
the thermostat
would read 72°F
instead of 70°F.
The installer
can select the
minimum run
time for the
compressor to
help protect the
compressor from
short-cycling.
The compressor
short cycle delay
setting
will not allow the
compressor to
be turned on for
5 minutes after
it was last
turned off in
order to protect
the compressor.
The cooling
differential is
factory preset at
0.5°. This means
that whenever
the room
temperature
heats by 0.5°
full degree from
the temperature
setting, the
cooling system
will turn on.
If the cooling
system turns
on too often,
increase the
temperature
differential.
The heating
differential is
factory preset at
0.4°. This means
that whenever the
room temperature
cools by
0.4° from the
temperature
setting, the
heating system
will turn on. If the
heating system
turns on too
often, increase
the temperature
differential.
LCD will show
Next Step Next Step
Next Step
Next Step Next Step
Next Step
Prev Step Prev Step
Prev Step
Prev Step Prev Step
Prev Step
Done Done
Done
Done Done
Done
INSTALLER SETUP MENU
9

Robertshaw RS8210 Specifications

General

Brand	Robertshaw
Model	RS8210
Category	Thermostat
Language	English