RoboCam F12 - Speaker Alarm Settings

Day&Night IP Camera
3.10. Speaker Alarm settings
The IP Camera provides speaker alarm function, a PIR or video motion detection
could trigger the speaker alarm. The duration of the alarm could also be set. The
related settings are explained below:
1. Speaker alarm trigger– select the trigger mode of the speaker alarm
A. Motion trigger – if this is selected, the speaker alarm signal will be active
when video motion is detected. The detection sensitivity is set In the “motion
detection” page.
B. PIR trigger – if this is selected, the speaker alarm will work when the PIR
sensor is detected..
C. Schedule – if this is selected, the speaker alarm is scheduled according to
the settings of scheduling in section 3.13.
D. Disable–disable the speaker alarm.
2. Alarm loop times – this is the number of the loop times of the speaker alarm.
Figure 3-17: Speaker Alarm Settings page
32