Day&Night IP Camera
A: It’s probably because the internet bandwidth (internet speed) is not big enough.
Please try to apply for a better internet connection from your Internet Service
Provider or decrease the bandwidth settings of the IP Cam. You can adjust the
bandwidth requirement of the IP Cam either from the PC software or login
into the web configuration page of the IP Cam to do the modification.
9. Does the IP Cam provide the recording function?
A: You can do the recording of the video/audio of the IP Cam on the PC
software. Another software 'Player' is needed to play the recorded vide/audio
files.
The camera could also do recording on Micro-SD card and NAS devices.
10. Can I connect the IP camera directly to my PC/notebook with an Ethernet
cable?
A: If the IP camera is directly connected to your PC/notebook computer using an
Ethernet cable, the IP camera will automatically use an IP address called “auto IP”
with IP address 169.254.xxx.xxx. If your PC/notebook computer is configured to
DHCP, it will also use an “auto IP” address. But this will take about one minute after
the IP camera is connected to the computer and you need to make sure that the WiFi
interface on your PC/notebook computer is disabled. After about one minute, you can
run the PC software to access the IP camera, the CAM ID should be displayed
on the “auto-search” list. You can then see the video by double clicking the CAM ID
icon. But you need to know that in this situation, other local or remote computer can
not see the video.
55
To Next Page
Loading...
