Robomow RK1000 User Manual

11 12
C. Lift Sensor
If the mower is manually lifted o the ground, the mower and rotation of
the blade will stop in two (2) seconds.
D. Tilt Sensor
If the mower is tilted up towards a vertical position, the mower and
rotation of the blade will stop in two (2) seconds.
E. Obstruction Sensor
Your mower detects interfering obstacles in its way during operation.
When the mower collides with an obstacle it will stop movement in that
direction, reverse itself away from the obstacle and the mower and
rotation of the blade will stop in two (2) seconds.
F. Quick Stop Control
Pressing down (RK and RT models) and/or pulling up (RK models) the
red STOP control at any time during operation will stop the mower and
the blade in (2) two seconds.
G. Removable Disabling Device
Pulling out the disabling device will prevent any operation of the mower.
It is required to pull the disabling device before lifting the mower and
before any maintenance is done.
H. Base Station/Perimeter Switch and Perimeter
Wire
The mower cannot operate without a Perimeter Wire installed and
activated through the Base Station/Perimeter Switch. In the event the
Perimeter Wire signal is turned o, the mower will stop operating.

Robomow RK1000 Specifications

General

Cutting Width	21 cm
Cutting Height	20-100 mm
Battery Type	Lithium-Ion
Battery Capacity	4.3 Ah
Max Lawn Size	1000 m²
Slope Capability	45%
Noise Level	60 dB
Battery Voltage	18 V
Charging Time	60-120 minutes
Working Time	60 minutes