50 51
Test wire
It is now time to test and adjust the location of the perimeter wire.
1) Remove the mower from the Base Station and place it facing the wire
behind the base.
2) Press the Go Home button.
The mower will drive forward and begin to follow the perimeter wire. As
it follows the wire, observe for the following possible situations:
A. Wire too close to obstacles
If the mower encounters an obstacle while following the wire, it will
maneuver around it. In these situations, adjust the wire further away
so that the mower will clear the obstacle without having to depart the
wire and navigate around it.
B. Wire too close to edge of lawn
If the mower falls o the edge of the lawn as it travels the wire,
adjust the wire further inward away from the edge.
C. Wire too far from obstacles and / or edge of lawn
Your mower has the unique ability to mow very close to obstacles
and the edge of your lawn. If you see areas where it would not mow
as close as you would like, simply adjust the wire further out. Just be
careful to avoid situations A & B.”
To Next Page
Loading...
Need help?
General
